In The News Archives - Page 3 of 7

11/03/2019

18,178

Can I Cut Vinyl/PVC In A Laser?

This question has been asked a few times so I thought it may be good to do a write-up about…

10/26/2019

6,212

So, in my other articles we covered the difference between Analog and Digital Control Panels (and why you need to…

11/02/2019

3,580

Every laser should be equipped with an ammeter so you can accurately measure the actual tube current. Just knowing the…

11/26/2019

10,917

There has been quite a bit of discussion as to which K40 control panel is “better”. This article will cover…

10/26/2019

1,638

NOTE: THESE INSTRUCTIONS ARE SPECIFIC TO SMOOTHIE FIRMWARE The Max Laser Output soft limit is 80% in the cohesion config…

10/26/2019

1,643

10/26/2019

1,979

Download: Download:

10/26/2019

3,565

10/28/2019

7,049

So this is the first test after optical alignment. I went with the copper pipe air assist (cost me…

04/11/2021

9,032

click image to enlarge Cyclops is a Chinese K40 40 Watt CO2 Laser Engraver that was purchased brand new from…