C3D Mini
-
Testing K40 Endstops With LightBurn
Sometimes endstops can cause some hard-to-find issues. If you have a Cohesion3D or other Smoothie based controller you can troubleshoot…
Read More » -
K40 Laser Custom Panel Ideas
K40 Custom K40 C3D Control Panel by Tech Bravo Here is the custom control panel I designed for Cyclops. Feel free to…
Read More » -
C3D 4 Axis Firmware & Config
Here is a step by step how-to for preparing the Cohesion3D Mini microSD card with the correct firmware and…
Read More » -
Custom K40 C3D Control Panel
Here is the custom control panel I designed for Cyclops. Feel free to use and modify this file as you…
Read More » -
Controller & DSP Identification
There are lots of laser controllers out there and they all have their pros and cons. This article will dig…
Read More » -
Checking C3D Equipped K40’s Origin in LightBurn
This is how to check the origin in LightBurn for the stock K40. See the links below for info on…
Read More » -
Beginners Guide To The K40 Laser Engraver
1. GENERAL INFORMATION If you are considering buying, or have just purchased a K40 Chinese Laser Engraver this Knowledgebase Article…
Read More » -
C3D Mini Origin & Stepper Cable Verification
This video goes over the correct origin settings in LightBurn after installing the C3D Mini. We also cover verifying the…
Read More » -
Setting Custom Bed Size For The Cohesion3d Mini
If you have a bed size other than 200×300 you can change the config on the MicroSD card supplied with…
Read More » -
C3D Mini External 24v PSU Connections
This is in response to a question posed about using an external 24v PSU to power motion control and the…
Read More »