Search Results for: cohesion3d
-
In The News
K40 Odin With Pipe Air Assist
So this is the first test after optical alignment. I went with the copper pipe air assist (cost me…
Read More » -
In The News
K40 Cyclops Information Page
click image to enlarge Cyclops is a Chinese K40 40 Watt CO2 Laser Engraver that was purchased brand new from…
Read More » -
In The News
FSL Gen.5 Hobby Laser Schematic
This unofficial diagram has been modified to show connections specific to board replacement with the Cohesion3D Mini. This is for…
Read More » -
C3D Mini
C3D Mini Standard Firmware & Config
Here is a step by step how-to for preparing the Cohesion3D Mini microSD card with the correct firmware and configuration…
Read More » -
C3D Mini
C3D Matching Steps To A Motor
NOTE: THESE INSTRUCTIONS ARE SPECIFIC TO SMOOTHIE FIRMWARE Lets say you replaced the X Axis stepper motor on your K40…
Read More » -
C3D Mini
Testing K40 Endstops With LightBurn
Sometimes endstops can cause some hard-to-find issues. If you have a Cohesion3D or other Smoothie based controller you can troubleshoot…
Read More » -
C3D Mini
K40 Laser Custom Panel Ideas
K40 Custom K40 C3D Control Panel by Tech Bravo Here is the custom control panel I designed for Cyclops. Feel free to…
Read More » -
C3D Mini
C3D 4 Axis Firmware & Config
Here is a step by step how-to for preparing the Cohesion3D Mini microSD card with the correct firmware and…
Read More » -
Controllers
M2 Nano Mainboard
The M2 Nano is the standard mainboard in many k40's and some 50-80 watt Chinese laser engravers. It provides basic…
Read More » -
C3D Mini
Checking C3D Equipped K40’s Origin in LightBurn
This is how to check the origin in LightBurn for the stock K40. See the links below for info on…
Read More »
