LightBurn
-
3D Relief Engraving - Attempt 4
So I tweaked a few settings and came out with this piece. This was done in LightBurn and lased on…
Read More » -
My 1st Attempt at 3D Engraving
I was fairly certain this would not come out very well so I didn’t even document the process but it…
Read More » -
LightBurn Can Change A Tire?
FROM THE DEVELOPER: A cheeky user asked, “I have a flat tire – should I get LightBurn?” It can’t fix…
Read More » -
LightBurn Lesson #1 – Installation For Gcode Users
LightBurn Lesson #1 – Installation for Gcode machines DUE TO THE STEADY ACTIVE DEVELOPMENT OF LIGHTBURN THIS INFORMATION MAY BE…
Read More » -
My 1st Attempt & Workflow For Jarvis Dithering
I have been using Photograv for my image manipulation and setting LightBurn to pass through up til now because, frankly,…
Read More » -
My First Attempt At Doing An Inlay
I’m glad to do this finally because my dad asked me about it a long time ago. I tried it…
Read More » -
A Christmas Ornament For My Grandson
This is another video in the Good, Bad, or Ugly uncut series where I do some file conversions, demonstrate the…
Read More » -
-
Controller And DSP Comparison
THIS MATRIX IS CONSTANTLY EVOLVING AND WE CANNOT GUARANTEE ACCURACY To contribute or suggest a correction please fill out the…
Read More »