Controllers
-
LightBurn Can Change A Tire?
FROM THE DEVELOPER: A cheeky user asked, “I have a flat tire – should I get LightBurn?” It can’t fix…
Read More » -
-
Control Software Comparison
THIS MATRIX IS CONSTANTLY EVOLVING AND WE CANNOT GUARANTEE ACCURACY To contribute or suggest a correction please fill out the…
Read More » -
Controller And DSP Comparison
THIS MATRIX IS CONSTANTLY EVOLVING AND WE CANNOT GUARANTEE ACCURACY To contribute or suggest a correction please fill out the…
Read More » -
MeerK40t Stock K40 Software
MeerK40t The Laser software for the Stock-LIHUIYU laserboard. MeerK40t (pronounced MeerKat) is a built-from-the-ground-up MIT licensed open-source laser cutting software…
Read More » -
C3D Mini GLCD Menu Tree
DRO (main menu) PLAY (navigate and run gcode on SD card) JOG Move 10mm X,Y,Z Move 1mm X,Y,Z Move .1mm…
Read More » -
Constant Power vs. PWM Control
So, in my other articles we covered the difference between Analog and Digital Control Panels (and why you need to…
Read More » -
Milliammeters: Analog vs. Digital
Every laser should be equipped with an ammeter so you can accurately measure the actual tube current. Just knowing the…
Read More » -
K40 Panels: Analog vs. Digital
There has been quite a bit of discussion as to which K40 control panel is “better”. This article will cover…
Read More » -
C3D Modifying Max Laser Output
NOTE: THESE INSTRUCTIONS ARE SPECIFIC TO SMOOTHIE FIRMWARE The Max Laser Output soft limit is 80% in the cohesion config…
Read More »