Trial & Error
-
My 1st Attempt at 3D Engraving
I was fairly certain this would not come out very well so I didn’t even document the process but it…
Read More » -
Thunder Laser Air Assist Control
BE PREPARED TO ADJUST THE VOLUME . THE FANS ARE FAIRLY LOUD IN THE VIDEO. Here is a test of…
Read More » -
Introduction to Laser Engraving
Introduction Laser Engraving. What is it exactly. According to Wikipedia: “Laser engraving, which is a subset of laser marking, is…
Read More » -
My 1st Attempt & Workflow For Jarvis Dithering
I have been using Photograv for my image manipulation and setting LightBurn to pass through up til now because, frankly,…
Read More » -
-
Embroidery Machines, 3D Printers, Lasers, Cameras, and More
This is an impromptu uncut video of me thinking out loud so it’s all over the place 🙂 and i…
Read More » -
My First Attempt At Doing An Inlay
I’m glad to do this finally because my dad asked me about it a long time ago. I tried it…
Read More » -
A Christmas Ornament For My Grandson
This is another video in the Good, Bad, or Ugly uncut series where I do some file conversions, demonstrate the…
Read More » -
My 1st Go Around With Whiteboard
This video delves into the first test of whiteboard which appears to be approximately 3mm total thickness. The core appears…
Read More »