In The News
-
LightBurn 0.9.05 – Variable Text, Image Enhancement, CorelDraw Macro, – LightBurn Software
FIRST THINGS FIRST – LICENSE RENEWALS, AND AN APOLOGY It was brought to our attention that a few expired licenses…
Read More » -
Can I Cut Vinyl/PVC In A Laser?
This question has been asked a few times so I thought it may be good to do a write-up about…
Read More » -
Constant Power vs. PWM Control
So, in my other articles we covered the difference between Analog and Digital Control Panels (and why you need to…
Read More » -
Milliammeters: Analog vs. Digital
Every laser should be equipped with an ammeter so you can accurately measure the actual tube current. Just knowing the…
Read More » -
K40 Panels: Analog vs. Digital
There has been quite a bit of discussion as to which K40 control panel is “better”. This article will cover…
Read More » -
C3D Modifying Max Laser Output
NOTE: THESE INSTRUCTIONS ARE SPECIFIC TO SMOOTHIE FIRMWARE The Max Laser Output soft limit is 80% in the cohesion config…
Read More » -
-
-
-
K40 Odin With Pipe Air Assist
So this is the first test after optical alignment. I went with the copper pipe air assist (cost me…
Read More »
